Keysight N3304A for Rent, DC Electronic Load Module, 300W, 60V, 60A/N330X Mainframes, 1 Slot

Product Highlights

The Keysight N3304A is a 300 W (0-60A, 0-60V) electronic load module for use in either the N3300A or N3301A electronic load mainframe in system applications. The N3304A load module is fast and accurate, for programming in constant current, constant voltage, or constant resistance modes, or for making voltage, current or power measurements. The N3304A can also digitize waveforms.

The N3300 Series supports up to six channels, each with a unique maximum voltage and current. They allow the design of a flexible automated test equipment (ATE) system to verify many types of power supplies, DC-to-DC converters, and batteries. Add additional modules to test multiple power sources simultaneously. Each module includes a 16-bit voltage, current, and power measurement system.

Increase Test Throughput

Today’s high volume manufacturing requires optimization of test system throughput, to maximize production volume without increasing floorspace. The N3300 Series electronic loads can help you in a number of ways to achieve this goal.

Reduced command processing time:

Commands are processed more than 10 times faster than previous electronic loads.

Automatically execute stored command sequences:

"Lists" of downloaded command sequences can execute independent of the computer, greatly reducing the electronic load command processing time and computer interaction time during product testing.

Programmable delay allows for either simultaneous or sequential load changes:

This is the most multiple output DC power supplies, simulating real-life loading patterns, with a minimum of programming commands.

Buffer measurement data:

Voltage, current, and power measurements can be buffered for later readback to the computer, reducing computer interaction.

Control measurement speed vs. accuracy:

Decrease the number of measurement samples to achieve greater measurement speed, or increase the number of samples to achieve higher measurement accuracy. You can optimize your measurements for each test.

Control rising and falling slew rates separately:

Reduce rate of loading change when necessary for DUT stability or to simulate real life conditions, but otherwise change load values at maximum rate.

• Increase test system throughput
• Lower cost of ownership
• Decrease system development time
• Increase system reliability
• Increase system flexibility
• Stable operation down to zero volts
• DC connection terminal for ATE applications
• Current: 0 - 60 A
• Voltage: 0 - 60 V
• Maximum Power: 300 W
• Low Range/High Range: 6 A/60 A
• Regulation: 10 mA
• Low Range Accuracy: 0.1% + 7.5 mA
• High Range Accuracy: 0.1% + 15 mA
• Low Range/High Range: 6 V/60V
• Regulation: 10 mV
• Low Range Accuracy: 0.1% + 3 mV
• High Range Accuracy: 0.1% + 8 mV
• Range 1 (I >10% of current rating): 0.033-2 ohm
• Range 2 (I >1% of current rating): 1.8-20 ohm
• Range 3 (I >0.1% of current rating): 18-200 ohm
• Range 4 (I >0.01% of current rating): 180-2000 ohm